Draper HG1601 Manuel du propriétaire télécharger pdf (Page 5)

ADDED SAFETY RULES FOR HOT AIR GUNS

- 4 -

NOTE: A FIRE COULD ARISE IF THIS HOT AIR GUN IS NOT USED WITH CARE.

1. Ensure that the hot air gun is switched OFF before connecting to the power supply.

2. Do not use this hot air gun as a hair dryer.

3. Do not touch the hot metal nozzle.

4. Allow the hot air gun to cool down completely before storing.

5. Do not direct the flow of hot air at persons or animals.

6. Do not hold the metal nozzle too close to the workpiece as the air flow will be restricted and

may cause the hot air gun to overheat. Position the nozzle at least 1" (25mm) from the work

surface.

7. Use in well ventilated area as poisonous or inflammable fumes or gases may be produced from

certain plastics, paints or similar materials.

8. When working with or near easily combustable materials and inflammable gases, take special

care. (Do not apply heat to any one area for long periods of time).

9. Heat may be conducted to combustible materials which are not visible from the work area.

10. Never leave the hot air gun running whilst unattended.

11. Do not look directly into the metal nozzle when the machine is switched on.

12. Place the hot air gun in its free standing position (see Fig.4 page 5) after use and allow it to cool

down before storing it.

13. THE CERAMIC RODS MAY BECOME LOOSE BUT IN NO WAY DOES THIS ALTER THE

SAFETY OR THE PERFORMANCE OF THE PRODUCT.

KNOW YOUR HOT AIR GUN

1. BS approved non-rewireable 3 pin moulded plug and cable.

2. ON/OFF, air flow and temperature control switch (three position).

3. Metal nozzle.

4. Hanging ring for storage/free standing support.

5. Air intake vents.

✖✌

✗✌

✘✌

✕✌

✙✌

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Draper HG1601 Manuel du propriétaire Page 5