Draper SC1 Manuel d'instructions télécharger pdf (Page 29)

10 Motor Power Panel

The 10 motor power panel is for powering the Low Voltage Radio Motor. It is not required, but it does make installation easier.

A transformer is still needed, and it will feed power to the panel. You can parallel wire the motors directly into the power feed off the trans-

former. This, however, makes connecting and disconnecting the motor from power to program it difﬁ cult and cumbersome. With a power panel

you can disconnect or connect each motor individually for programming, this will make installation quicker.

A power panel is also set-up to work with wiring that might have been pulled for a different system.

The diagram below shows the panel and how motors plug into it.

12/24V DC

Input

Po we r

LED’s

2A Fuse

22 Gauge/2 conductor

150 Ft. Maximum

Power Supply Input

Connect motor to

terminals 5 & 6 of

motor connector

Connect motor

connector to

power panel

Sonesse 30 Motor

18 Gauge/2 Conductor

5 Ft. Maximum

Sonesse 30 Motor

Page 29 of 120

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 119 120

Pas de commentaire

Draper SC1 Manuel d'instructions Page 29