Draper SC1 Manuel d'instructions télécharger pdf (Page 34)

Motor Pigtails and Disconnects

Motor Pigtails are a standard of 6’ with a 18 gauge 3 conductor with a ground on 4 wire motors. It is a 18-2 with 3 wire motors. The pigtails do

come in longer lengths up to 24’.

3 wire pigtails also can come with an optional 3 prong plug (see page 20).

All motor pigtails are not plenum rated. They are a PVC jacketed cable with a diameter of

/16".

Quick disconnect plugs come as a standard on Motorized Flexshades with brackets, fascia, or headbox (excluding small pocket headbox). They

are not on Motorized Flexshades in Access Pockets (single, dual or ultimate), and they are not on Lightblocs, Colossals, Flexshade 2s, skylights

or Romans.

The male plug is one foot off the motor. The female lead which can be sent early is toward the J-Box. It is available in 5' lengths (Part C116.030)

as a standard, but you can also order female leads at 11' (Part C116.031), 17' (Part C116.032), and 23’ (Part C116.033).

The female lead can be replaced with a wall entry plate, C201.001, for plugging the male connector into the wall or J-box face plate.

The picture below is the standard plug set-up. Each plug is 2" long so 4" when together.

The female is 1¼" w at the base and

/8" wide at the neck. It is

/8" high.

The male plug is 1¼" w at the base and 1

/8" wide at the neck. It is

/8" high.

Page 34 of 120

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 119 120

Pas de commentaire

Draper SC1 Manuel d'instructions Page 34